DodgeCoronet.com

Full Version: What did you do to your Coronet this Week ....???
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
67RTBlue Wrote:I'm still scratching my head! Hey if it worked though! This reminds me of balancing a ceiling fan. That procedure always made my head hurt.
When I did ours I had DTS replace the joints and balance it.

Unrelated. Rear leafs are squeaking. Sounds like the front bushing. I know your not supposed to oil or grease them?? Brand new S/S sprint assemblies. Front spring bolt too tight? Too loose?

It just takes a lot of patience. I crawl under and moved the clamps at least 50 times just being very careful to really understand if it felt better or not.

Can they be too tight? The bushing should not let them be squished too much. Original or Polyurethane? I use Energy Suspension Polyurethane kit for all my suspension. I was worried about that but I used the supplied lube and not noises yet.
Original rubber per the repop springs
10916]

Max was put in storage while we took care of relocating our shop, and yesterday I went and picked it up. I was so excited like someone going down to pick up there new car they ordered.

Damn it runs so good. Banging Gears
67r/t4speeder Wrote:10916]

Max was put in storage while we took care of relocating our shop, and yesterday I went and picked HIM up. I was so excited like someone going down to pick up there new car they ordered.

Damn it runs so good. Banging Gears

I fixed that post for you Andy! Wink

Richard
ooops
When's the "Grand Opening"???
Racer Brown Wrote:When's the "Grand Opening"???

When Mike shows up with lots of hot BBQ, cold Beer and a yellow convertible.

Richard
67r/t4speeder Wrote:ooops

Our metal children's feeling are easily hurt Andy! BlondeRofl

Richard
Modified a '67 air cleaner to fit on my FiTech EFI throttle body. Now I am EFI Stealth.... Engine Compartment is complete!
10954]10955]10956]10957]10958]10959]
Good Job! How you like the Fitech setup?