Wiring Issue

[markbob@ameritech.net]

Hey everyone....

am installing my wiring harness in the dash of the 69 Coronet....

I had my harness redone by Mr Heaterbox....as well as my heater control panel....

I am trying to connect everything up....and the harness has a Dark Green wire labeled heater control...

My heater control has 4 wires coming out of it, and these appear to connect the heater control with the
heaterbox resistor....

it appears I am missing something, as I have connected the heater control to the heaterbox resistor, but there is no power to the control....

can anyone help?

thanks,

Mark

[4264door]

Have you checked the fuse feeding the heater control?

[markbob@ameritech.net]

Hello.....

I figured it out......the heater control has 4 wires with 3 in one connector, and 1 in the other....
The heaterbox resistor has room for 2 connectors....I believe the dash harness connects with the single connector on the heater control, and the connector with the 3 wires goes to the heaterbox....this brings power to the resistor in the heaterbox...
the other lead on the resistor is for the heater blower motor....

hopefully I didn't confuse anyone with this rediculous post...

Mark

[markbob@ameritech.net]

Well now another wrinkle
I checked the fuse block with a light tester
I have power coming in the bottom of the nimber two (L to R)
slot but nothing coming out the top
the number 6 has nothing coming in either too or
bottom
i suspect a bad fuse on number 2 but number 6 is
baffling

will repost once i get the steering column hooked up