Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Starter for 1958 Dodge Coronet
#1
I'm looking for a gear reduction starter for my 1958 Dodge Coronet. Can someone send me recommendations on what to get and where to buy it? My current starter takes a lot of cranking power to turn over the engine and sometimes barely turns the engine over when going on short trips with frequent turning of the engine off/on. So I'm hoping there's a newer after market gear reduction starter compatible that will work as a replacement for the original. My engine is an original v8 325.
Reply Purge Spammer

#2
I looked on rock auto and they are out of stock. I’m not sure if anything is compatible with that motor. Is there a place local to you that rebuilds starter motors? A good source for info is forwardlook.net for your car, check it out if you haven’t already.
Clean as a whistle 
Smelling like a rose
Reply Purge Spammer

#3
Maybe one of these will work for you?

https://hothemiheads.com/transmission_ad...ement.html
Reply Purge Spammer

#4
https://www.summitracing.com/parts/pwm-9.../year/1958
Reply Purge Spammer



Possibly Related Threads…
Thread Author Replies Views Last Post
  1969 Coronet A39 Super Bee Scat Pack Spring Special option code 1958300 1 9 08-23-24, 09:20 AM
Last Post: 67r/t4speeder
  1967 Coronet 'Restoration' Piper 29 201 07-27-24, 05:12 PM
Last Post: juan a.
  Front End Alignment Shop for 1967 Coronet 440net 2 12 05-29-24, 04:14 PM
Last Post: 440net
  dodge coronet super bee rear trim ramiroflores 1 14 05-08-24, 09:28 AM
Last Post: 67440Dodge
  Trying to find my grandpas 1968 coronet rt. mason 4 33 01-29-24, 11:11 AM
Last Post: 67440Dodge
  1970 Coronet 500 new to me. SteveSS 13 57 01-25-24, 03:08 PM
Last Post: 67r/t4speeder
  Power Brake Conversion for 1958 Coronet acer 5 24 11-20-23, 09:20 AM
Last Post: 65rbdodge
  Coronet update. 493mike 11 52 10-23-23, 09:06 PM
Last Post: 67440Dodge
  Welcome to the new and improved Dodge Coronet Forum!! 67440Dodge 4 52 10-07-23, 02:06 AM
Last Post: 67440Dodge
  '67 Coronet Trunk Gasket stonehengeheels 3 1,764 08-26-22, 11:29 AM
Last Post: 67440Dodge

Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2024 Melroy van den Berg.