Login

Hibbing_Coronet_500 · 02-19-13, 11:05 AM

I have looked all over the internet for the proper way to adjust the kick down linkage on a big block with a 727. I have the factory linkage and springs.Right now... I have it set.... @ Full throttle... it moves linkage "all" the way to the rear. With the return spring keeping slotted arm tight against the pin. It just dont seem right?Thanks you.

theman440 · 02-19-13, 01:51 PM

The best way to adjust it is in small increments road testing it after every adjustment. Adjust it untill it shifts when you want it to at full throttle. The spring is supposed to pull the arm back against the pin.

Possibly Related Threads…
Thread		Author	Replies	Views	Last Post
	Lower control arm question	Piper	2	19	10-17-23, 01:57 PM Last Post: theman440
	Question	theman440	23	2,984	06-02-22, 01:39 PM Last Post: theman440
	Vin # decode and emblem question.	Rcrail	4	3,997	03-07-20, 03:38 AM Last Post: thebankerstoy
	Six Pack Linkage with tti headers	Piper	6	5,438	06-20-16, 02:56 AM Last Post: thebankerstoy
	Heater control cables-routing question	67RTBlue	4	4,420	06-16-16, 03:23 PM Last Post: 67RTBlue
	Valve body question	tgranthamfd	2	2,771	02-22-16, 02:16 AM Last Post: tgranthamfd
	Brake drum/wheel stud question	rlsbee	13	5,967	02-02-16, 11:45 PM Last Post: 67440Dodge
	Upper arm shifter linkage bushing source	DodgeT	0	2,267	01-24-16, 02:47 PM Last Post: DodgeT
	Distributor question	67RTBlue	9	6,884	01-09-16, 11:13 AM Last Post: 1badstroker
	Brake line question-passenger side line hump or no hump?	67RTBlue	2	2,934	01-07-16, 11:12 PM Last Post: 67440Dodge