Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Head question
#1
Dug the new motor out from under the bench and got it on the stand.. From what I can see, the heads were milled a bit. Any way to tell how much without pulling the heads off?

I'm fairly sure not, but before I go tearing it down to check head volume, figured I'd see if there was some old school trick to checking.
I love Mopars so much I'm date coding the skid marks in my underwear.
Reply

#2
Did you find a way of checking with heads on ?
The Idaho Andy
I love the smell of race fuel in the morning
Reply Purge Spammer

#3
No.. the only place I could reference was a intake bolt hole to a straight edge on the underside of the head. I compared that to 4 other sets of heads I have, but since I don't know if they were cut in the past, there was no true reference to go by.. Since the motor is on the stand I just pulled em off and will CC em..
I love Mopars so much I'm date coding the skid marks in my underwear.
Reply



Possibly Related Threads…
Thread Author Replies Views Last Post
  Lower control arm question Piper 2 19 10-17-23, 01:57 PM
Last Post: theman440
  Question theman440 23 2,984 06-02-22, 01:39 PM
Last Post: theman440
  Vin # decode and emblem question. Rcrail 4 3,997 03-07-20, 03:38 AM
Last Post: thebankerstoy
  Heater control cables-routing question 67RTBlue 4 4,420 06-16-16, 03:23 PM
Last Post: 67RTBlue
  Valve body question tgranthamfd 2 2,771 02-22-16, 02:16 AM
Last Post: tgranthamfd
  Brake drum/wheel stud question rlsbee 13 5,967 02-02-16, 11:45 PM
Last Post: 67440Dodge
  Distributor question 67RTBlue 9 6,884 01-09-16, 11:13 AM
Last Post: 1badstroker
  Brake line question-passenger side line hump or no hump? 67RTBlue 2 2,934 01-07-16, 11:12 PM
Last Post: 67440Dodge
  67 Coronet power window question Lipers1 8 5,324 10-11-15, 01:47 AM
Last Post: thebankerstoy
  New owner - Choke question/FM Converter tuckerboynton 6 4,782 07-12-15, 05:09 PM
Last Post: Redneck

Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2024 Melroy van den Berg.