ride height

[BooBoo]

I got a 67 coronet and the passenger side sets about a inch and a half higher then the drivers side . what would cause this ? thanks . booboo

[67r/t4speeder]

Front or rear? Is the car rusty around torsion Mounts? If OK it might be just adjustment off with torsion, or bad leaf spring.
Pics would help.

[67RTBlue]

This reminds me. Does anyone have ride height specs? I feel like the front end is low at times and wonder if I should give the bars a few turns?

[BooBoo]

front , no rust . how do you adjust them ? thanks

[67r/t4speeder]

Do have access to a service manual? I can explain it, but manual is much better.

[67RTBlue]

Do have access to a service manual? I can explain it, but manual is much better.

I have one but it's either missing "figure 1-15" or I'm blind! Honestly I've scanned that thing a few times and can't find any actual measurements and where they're made.

[67r/t4speeder]

I have one but it's either missing "figure 1-15" or I'm blind! Honestly I've scanned that thing a few times and can't find any actual measurements and where they're made.

I will check tomorrow also.

[BooBoo]

thanks guys . found it on youtube . 2 bolts , turn them one way and the car goes up . turn them the other way and the car goes down .

[Mark's 69]

From a Motor Manual
My manual only goes back to 1968, but the specs for 68 to 74 are the same at 1&7/8" so I would guess a 67 is the same.

[Racer Brown]

Jack up the car, magic marker a line on the socket for referance, crank each torsion bar up or down the same number of turns and see what you've got, maybe one's off a turn or so.