Posts: 113
Threads: 6
Joined: Jan 2013
04-02-17, 11:18 PM
(This post was last modified: 04-02-17, 11:22 PM by badmopar67.)
I looks really good and great Idea using the plastic pushpins because I know the original clips are nonexistent
I was also contemplating using 3m double-sided tape because I don't have the holes I was trying to avoid drilling any
67 R/T 440ci 4spd
[SIGPIC][/SIGPIC]
Posts: 529
Threads: 79
Joined: Sep 2014
badmopar67 Wrote:I looks really good and great Idea using the plastic pushpins because I know the original clips are nonexistent
I was also contemplating using 3m double-sided tape because I don't have the holes I was trying to avoid drilling any
Thats not a bad idea either. They make adhesion promoter wipes that REALLY makes the tape stick. I only recommend applying it to the molding side. After that stuff is applied you don't get a chance to reposition! A technique to avoid lifting/repositioning is to leave the backing on except for one end where you peel back an inch or two. Line the molding up and then have a helper start to pull the backing as you keep it positioned. Careful not to break the backing as your pulling!
