+- DodgeCoronet.com (https://dodgecoronet.com/forum)
+-- Forum: Tech Discussion (https://dodgecoronet.com/forum/forumdisplay.php?fid=4)
+--- Forum: Tech Q&A (https://dodgecoronet.com/forum/forumdisplay.php?fid=16)
+--- Thread: Flat Tappet Cam Q (/showthread.php?tid=781)
Flat Tappet Cam Q - Piper - 04-14-13
Is a brass bushing and/or a hardened oil pump shaft needed when running a flat tappet cam
I forget if it should, or is that with the billet/rollers?...I was looking at my 440 and its looks like the stock stuff in there
(its running a .528 mech)
Flat Tappet Cam Q - 67440Dodge - 04-14-13
Hardened shaft only needed for roller..
Flat Tappet Cam Q - BooBoo - 04-14-13
Unless Dodge is differnt then Chevy, the only diff is you need a brass dist gear . BooBoo .
Flat Tappet Cam Q - BooBoo - 04-14-13
Opps , I,m sorry , You need the brass gear on the dist if its a roller cam . Sorry bout that . BooBoo
Flat Tappet Cam Q - ws27 - 04-14-13
I thought the hardened pump shaft was only if you are running a high volume oil pump. Does the flat tappet cam do something to the oil pump shaft?
Flat Tappet Cam Q - Piper - 04-14-13
mostly likely not....i remember having to get both for the 4 speed..because there was "stuff" done to it