+- DodgeCoronet.com (https://dodgecoronet.com/forum)
+-- Forum: Tech Discussion (https://dodgecoronet.com/forum/forumdisplay.php?fid=4)
+--- Forum: Coronet Restoration/Paint Shop/Body Shop (https://dodgecoronet.com/forum/forumdisplay.php?fid=17)
+--- Thread: '66 Coronet outer wheelhouse...end caps...cross member... (/showthread.php?tid=2707)
'66 Coronet outer wheelhouse...end caps...cross member... - derek - 04-21-15
Having trouble finding outer wheelhouses for 66-67. Should I order the 68-70 and make them work, or are there any other ideas or resources?
Also need to find end caps for my trunk floor extensions.
And one more - rear cross member where the bumper reinforcements are located. Found some on Auto Body Specialty, but there is just a diagram, no picture. Is that what I need?
'66 Coronet outer wheelhouse...end caps...cross member... - 67440Dodge - 04-21-15
Having trouble finding outer wheelhouses for 66-67. Should I order the 68-70 and make them work, or are there any other ideas or resources?
68/9 are completely different beasts when it comes to outer wheelhouses. Your best bet is to try and find a donor car that may have a solid piece, or try to fabricate the sections that are missing. You can also contact Auto Rust Technicians in Rhode Island. They might be able to fabricate a set.
Also need to find end caps for my trunk floor extensions.
Might want to check Sherman & Associates parts. they used to carry those pieces, but not sure anymore.
And one more - rear cross member where the bumper reinforcements are located. Found some on Auto Body Specialty, but there is just a diagram, no picture. Is that what I need?
if you are talking the panel that goes across from each side of the car in the back behind the bumper, yes that is it.
'66 Coronet outer wheelhouse...end caps...cross member... - cd45harris - 04-23-15
I use Desert Vally Auto Parts for moments like these. They always send good quality used parts pulled from thousands of cars, huge selection. http://www.DVAP.com
'66 Coronet outer wheelhouse...end caps...cross member... - derek - 04-23-15
Thanks guys for your input.