What is a cleaner way to route the wires for the MSD and fuel pump rather than have them hang off the positive cable? Its a mess in here
How about the large post on the starter relay?
Firewall ground? Also straighten all the kinks out in the wires-will look a lot better.
everyhting is getting redone evetually and those were just run to re arrange some things, I was thinking there was a remote power distribution block or something I could use ..but not sure where
The starter relay is kinda like a remote distribution block. The large post on it is battery positive, the stud usually sticks out well past the nut so there's plenty of room to add more wires for your add-ons.
11658
Auto Zone or Advanced Auto sells a fuse block that takes a single input wire and allows the fused voltage to be distributed from there. I mounted mine on the heater box inside the passenger compartment next to the EFI controller.
11661
Thanks for the ideas guys!
Where's your headlight harness? Don't try driving in the dark! LOL