DodgeCoronet.com

I just purchased one of these very handy crankshaft harmonic balancer holding tools from Rick Ehrenberg on Ebay. A very simple designed tool that bolts to the harmonic balancer with two bolts and then allows you to insert a square drive 1/2" breaker bar into the square opening on the opposite end of the holding tool to hold the harmonic balancer in place while you're loosening, or tightening the large crankshaft mounted bolt. This tool will work on any big or small block Mopar engine and on both aftermarket and stock harmonic balancers as well.

Richard

This tool is currently out of stock

Nice Richard

It sure beats having to use other captain caveman ways of holding the crankshaft and harmonic balancer from turning while you're trying to bust that large crankshaft bolt loose or tightening it up. I bet you'd use it often at your shop Andy. Ran just at $31.00 with shipping.

Richard

Bump