10-23-16, 06:05 PM
10-23-16, 06:58 PM
The last of the exterior is back on the car now. The hood letters, I have another front bumper but will use this one for now. I have a tow bar set up I made for this one. Just some interior stuff left to find and put back on. Visible at certain angles between the d & G is a little mishap I had with the air hose caused by tight quarters in the garage.
11-10-16, 11:10 AM
The other night I installed the front window sweepers I purchased, but before I put them on I switched out the passenger side wing window because the locking arm was broken.
11-10-16, 11:55 AM
What brand sweepers and did they fit ?
11-10-16, 11:45 PM
I don't know what brand they are, I bought them off the mopar traders page on Facebook. They do fit well but the inside has a wider chrome edge than the ones I took off but I like how they look.
11-16-16, 02:21 AM
My new tires arrived today, they were on the porch when I got home from work. I went with 275 60s instead of 275 50s this time.
11-16-16, 11:52 AM
Hey I need some stickies like that too 
12-04-16, 01:24 AM
The basic seal kit from Just Mopar, arrived today. It's a Metro Soft brand product with both door and roof rail seals and also the trunk lip seal. I've read good reviews about their products so I'm hoping they fit and aren't to difficult to install. I also ordered a pentastar for the passenger side fender too because I lost the one I got from a member awhile back.
It looks like the toy drive/car show scheduled for tomorrow has been postponed because of the rain here in Texas. At least I have more time to get the car ready
It looks like the toy drive/car show scheduled for tomorrow has been postponed because of the rain here in Texas. At least I have more time to get the car ready
12-04-16, 10:13 AM
RT K_line Wrote:The basic seal kit from Just Mopar, arrived today. It's a Metro Soft brand product with both door and roof rail seals and also the trunk lip seal. I've read good reviews about their products so I'm hoping they fit and aren't to difficult to install. I also ordered a pentastar for the passenger side fender too because I lost the one I got from a member awhile back.I just got my Pentastar as well. It's the little things that make a difference.
It looks like the toy drive/car show scheduled for tomorrow has been postponed because of the rain here in Texas. At least I have more time to get the car ready
12-05-16, 02:23 AM
Tonight I worked on the trunk seal and passenger side door and roof rail seals. They went on fairly easy so far. I had to readjust the trunk lid and still am putting some weight on one side to for the seal to mold itself. I may end up having to bend the lip slightly because the passenger side is still sticking up. I'll recheck it tomorrow. The roof rail seal is going on nicely but I still have a piece of the old molding at the back corner so I'm going to have to take out the rear seat and side panel to remove it. The door seal is going on ok but I'm having to glue the front piece so I can stretch the rubber to match the holes for the pins. Also am going to splice the window edge seal to the door seal. It looks as though the factory door seal is part of the window seal or it might just overlap it.