Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Lower quarter panel
#11
Please please please don't use a stick welder. Borrow a wire feed if neccesary for better control or you'll warp your panels so bad you will have to replace them. Even brazing with oxy-acetylene is a better option than arc welding.
Reply Purge Spammer

#12
+1!!!
Castles made of sand slip in to the sea....eventually
Reply Purge Spammer

#13
Sounds like I need a Fathers day present for myself from Sears. Thanks
Reply Purge Spammer

#14
Wire feed welders have come down in price. I'd buy a machine that has gas capabilities or stick with the non gas flux core wire. Gas gives cleaner results over flux core.
I got my Hobart 140 with gas attachment for less than $500.
Reply Purge Spammer

#15
please you a MIG WELDER on the quarters and not stick weld it .....
Reply Purge Spammer



Possibly Related Threads…
Thread Author Replies Views Last Post
  Anyone doing ´67 chrome trunk panel reproductions? Irores 6 24,420 03-26-19, 12:42 PM
Last Post: Irores
  1970 Tail Finish Panel Hardware Piscataway Pete 1 16,507 03-16-19, 08:50 AM
Last Post: 67440Dodge
  Painting chrome-taillights & finish panel 67RTBlue 18 13,647 11-02-16, 08:21 PM
Last Post: Red 67
  Coronet sail panel chrome help needed RT K_line 3 5,403 07-12-16, 07:22 PM
Last Post: thebankerstoy
  67-R-T-Trunk-Panel smhemi 4 4,745 01-31-16, 08:18 PM
Last Post: smhemi
  67 500 badge on trunk panel paint codes mocam8 3 4,336 06-09-15, 01:32 PM
Last Post: Racer Brown
  Trick to install the dreaded lower dash bezels Billb66 0 3,162 02-26-15, 04:24 PM
Last Post: Billb66
  Rear quarter extension question? Warhawkfight34 3 4,678 07-31-13, 04:24 PM
Last Post: ws27
  Replacing panel with gas tank door on it cnmsales 14 8,181 03-10-13, 11:05 PM
Last Post: cnmsales

Forum Jump:


Users browsing this thread:
1 Guest(s)

Powered By MyBB, © 2002-2025 Melroy van den Berg.