+- DodgeCoronet.com (https://dodgecoronet.com/forum)
+-- Forum: Tech Discussion (https://dodgecoronet.com/forum/forumdisplay.php?fid=4)
+--- Forum: Tech Q&A (https://dodgecoronet.com/forum/forumdisplay.php?fid=16)
+--- Thread: 69 Coronet Brake System (/showthread.php?tid=926)
69 Coronet Brake System - markbob@ameritech.net - 05-18-13
Hey all....
have a 4 wheel power drum brake system....
I have all new stainless brake lines and wheel cylinders....
the proportioning valve and master cylinder are original to the car when I purchased it...
I hooked everything up, and bled the front brakes....then I moved to the rear....everything was fine until the rear of the master cylinder began leaking and fluid ran down between the master cylinder and brake booster....
I purchased a new master cylinder, and installed it....
today I filled it up and began to bleed the brakes....I bled the front and it appeared to go fine....
I tried to do the rear brakes and there is no fluid coming out of either side....
I disconnected the ss line from the rear flexible line.....no fluid in there either(other than a few drops).
I moved to the proportioning valve, and loosened the line that goes into the top of it from the master cylinder....a hiss and some fluid....
I tried the front brake line ports....got fluid to come out....
I tried the rear brake line ports, and nothing....not a drop
any ideas? I am thinking it's either a bad master cylinder, or there is a blockage in the forward line that sends fluid to the rear brakes....
Help...please!
Mark
69 Coronet Brake System - ws27 - 05-18-13
You most likely have to bleed the master by itself. Or, it you have a hand vacuum pump, you try that at the back. Sounds like you just have some air.
69 Coronet Brake System - markbob@ameritech.net - 05-31-13
Hey all
removed master cylinder and adjusted rod that comes
out of booster about 1/8 of an inch
the brakes wirk great now.... The brake pedal action is correct now too
69 Coronet Brake System - 67r/t4speeder - 05-31-13
Just make sure the brakes are not dragging now, too tight. Glad you figured it out.