+- DodgeCoronet.com (https://dodgecoronet.com/forum)
+-- Forum: Tech Discussion (https://dodgecoronet.com/forum/forumdisplay.php?fid=4)
+--- Forum: Tech Q&A (https://dodgecoronet.com/forum/forumdisplay.php?fid=16)
+--- Thread: Gasket or No gasket (/showthread.php?tid=4351)
Gasket or No gasket - 67r/t4speeder - 10-09-25
Since I am putting a replacement exhaust manifold on Junior I was looking at gaskets checking port sizes and all then I remember most of the new engine builds I did they were installed with no gaskets just a thin film of high temp sealant. This is if your manifold is flat. I will put a pipe gasket on.
I would like to hear what you guys do and have good luck with.
RE: Gasket or No gasket - theman440 - 10-09-25
Andy,
I have done it with new manifolds and old ones only after they have been surfaced with a belt sander. Never had a problem -