+- DodgeCoronet.com (https://dodgecoronet.com/forum)
+-- Forum: Where The Fun Happens (https://dodgecoronet.com/forum/forumdisplay.php?fid=3)
+--- Forum: General Discussion (https://dodgecoronet.com/forum/forumdisplay.php?fid=12)
+--- Thread: The road less traveled... (/showthread.php?tid=2938)
The road less traveled... - ws27 - 09-15-15
I'm not sure why I get into such projects...
The road less traveled... - 67r/t4speeder - 09-15-15
Your car you were doing before Rich?
The road less traveled... - ws27 - 09-15-15
It's not the cars, the letters are plastic. Those are the prototypes.
The road less traveled... - 67RTBlue - 09-15-15
Where's the final holy grail pieces-the R/T emblem on the qtrs!
Nice work!
The road less traveled... - ws27 - 09-16-15
67RTBlue Wrote:Where's the final holy grail pieces-the R/T emblem on the qtrs!
Nice work!
It's going to be a little while before even the letters are cast.
The RT emblem will be a legal problem unless I get it licensed, something I'm not ready to tackle right now. I do have a set of NOS ones to copy though.
I'm climbing the learning curve at this point.
The road less traveled... - 67r/t4speeder - 09-16-15
3D printer do those letters? Nice going Rich
It would be interesting to see how the factory did them with no high tech equipment
The road less traveled... - Racer Brown - 09-16-15
Those look neat, Rich!
The road less traveled... - 67RTBlue - 09-16-15
ws27 Wrote:It's going to be a little while before even the letters are cast.
The RT emblem will be a legal problem unless I get it licensed, something I'm not ready to tackle right now. I do have a set of NOS ones to copy though.
I'm climbing the learning curve at this point.
But what about one off copies you made for just yourself...
The road less traveled... - ws27 - 09-16-15
67r/t4speeder Wrote:3D printer do those letters? Nice going Rich
It would be interesting to see how the factory did them with no high tech equipment
They were done with a 3D printer Andy. They're a little crude, but they are correct in dimensions.
Once I am convinced they are correct, a brass set will be milled to make the molds. Like I said before, this is a big learning curve I hope works out.
The road less traveled... - ws27 - 09-16-15
67RTBlue Wrote:But what about one off copies you made for just yourself...
Unfortunately, it still won't be legal.