DodgeCoronet.com

There are a bunch of great folks here on the DCR. I have been fortunate enough to meet a few members in person over the years, purchased some nice parts and even got parts for free. Recently DCR member Mark Z did some very nice work on my valve covers for me and I want to give him a BIG thank you. He installed a custom oil fill plug and fabricated some 1/4 spacers for them. The workmanship is superb and he went out of his way to make sure they came out right - and they did. He went so for as to ask Indy Cylinder head for valve cover bolt pattern dimensions and even sent me templates to check fitment on the heads. Take a look at his work -

These covers had no holes in them other than the bolt holes, now I can put oil in the engine!

1220012201

The spacers are 1/4 thick.

12202


The spacers are screwed to the valve covers with tiny screws and they will seal to the head with an o-ring so no more valve cover gaskets!


1220512204


Lastly he counter sunk the bolt holes so the allen-head bolts will be flush.


1220612207


These valve covers are gonna stand out at the next Mopar event I attend and I'm sure somebody is going to ask me about them.

Thanks again Mark!

That's some quality machine work there.

Very nice.
You making your own o rings?

Wow... figure the odds on having a high dollar machine shop make something like that for you..

My pleasure.

I have a large roll of o ring material and just glue the ends together.

Nice work!

markz Wrote:My pleasure.

I have a large roll of o ring material and just glue the ends together.

I had a flash back when you mentioned a roll of oring.
I use to sit at a table and tap copper wire into the cylinder head groove on the alcohol car when needed. About as much as re stripping the blowers..

that is amazing,