On the bearing cap, get a pair of wire cutters and put three or four kinks in edge that fits hub and work it back in place.
Valvoline vr1 works for me and easy to find local
thanks so much for all the replies gotta wait til my next paycheck to finish her up.
Going today to insure and register her then a tune up and she's back as my everyday driver after 2 years sitting!! Tired of driving my "modern" car haha
shes legal!! drove her to work today and ran fine!! just needs alignment and new exhaust
sgp0511 Wrote:shes legal!! drove her to work today and ran fine!! just needs alignment and new exhaust
Thumbs up !! you did it
yea was nervous driving to work today (18 miles) but ran fine other than a little tire squeal on turns (needs alignment) and the old exhaust is killing me (probably literally) its a bad single turned dual exhaust job me and my friend did in high school, leaks everywhere, sounds horrible lol. So any ideas whats the best route, i want basically the stock single exhaust back. I know i need to go to an exhaust shop, but does anyone have a ballpark range of what i should expect to pay for single exhaust from the manifolds back?
i dont want anything fancy, just something not as loud and cheap bc funds are very low right now and i dont want to be breathing these fumes long, plus smelling like old exhaust at work isnt fun