DodgeCoronet.com

I went from a single pot master to a dual pot... finishing up plumbing the lines shortly which will take me to the next journey... filling and bleeding the entire system. I read the directions on bench bleeding the master, which seems pretty straight forward. What is the best way to get the entire system filled and bled? There are about a million takes on bleeding tools, anyone had good luck with one more than the others? Any advice is helpful, thanks!

Take your time and get every little bubble out when you bench bled, it will pay off .
Keep checking fluid level as your bleeding system out, can't let it run out or you need to start over.